On Sun, Feb 28, 2021, at 9:44 AM, Doug H. wrote:
> And you did ask for ethtool output while working:
I just realized that the ethtool output from the Pi side had only the single
100Full as advertised. It still needed a reboot after some tests to lock them
both to 100Full. I ended up rolling that back but the Pi still needed a reboot
to fully change, so the post reboot output is:
$ s ethtool eth0
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supported pause frame use: Symmetric Receive-only
Supports auto-negotiation: Yes
Supported FEC modes: Not reported
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Advertised FEC modes: Not reported
Link partner advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Link partner advertised pause frame use: Symmetric Receive-only
Link partner advertised auto-negotiation: Yes
Link partner advertised FEC modes: Not reported
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: pumbag
Wake-on: d
Current message level: 0x00000007 (7)
drv probe link
Link detected: yes
Since this is a change, I will go ahead and reboot to make sure the issue is
still there and that the new kludge/fix still works.
--
Doug Herr
[email protected]
_______________________________________________
users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
Fedora Code of Conduct:
https://docs.fedoraproject.org/en-US/project/code-of-conduct/
List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines
List Archives:
https://lists.fedoraproject.org/archives/list/[email protected]
Do not reply to spam on the list, report it:
https://pagure.io/fedora-infrastructure
