Dne 15. 03. 19 v 12:32 Adam Budziński napsal(a):
Hello Folks,____
__ __
Tow node active/passive VMware VM cluster.____
__ __
/etc/hosts____
__ __
10.116.63.83 srv1____
10.116.63.84 srv2____
172.16.21.12 srv2cr1____
172.16.22.12 srv2cr2____
172.16.21.11 srv1cr1____
172.16.22.11 srv1cr2____
__ __
__ __
I have 3 NIC’s on each VM:____
__ __
10.116.63.83 srv1 and 10.116.63.84 srv2 are networks used to
access the VM’s via SSH or any resource directly if not via a VIP.____
__ __
Everything with cr in its name is used for corosync communication, so
basically I have two rings (this are two no routable networks just for
that).____
__ __
My questions are:____
__ __
__1.__With ‘pcs cluster auth’ which interface / interfaces should I use
?____
Hi Adam,
I can see you are using pcs-0.9.x. In that case you should do:
pcs cluster auth srv1cr1 srv2cr1
In other words, use the first address of each node.
Authenticating all the other addresses should not cause any issues. It
is pointless, though, as pcs only communicates via ring0 addresses.
__2.__With ‘pcs cluster setup –name’ I would use the corosync interfaces
e.g. ‘pcs cluster setup –name MyCluster srv1cr1,srv1cr2 srv2cr1,srv2cr2’
right ?____
Yes, that is correct.
__3.__With fence_vmware_soap inpcmk_host_map="X:VM_C;X:VM:OTRS_D" which
interface should replace X ?____
X should be replaced by node names as seen by pacemaker. Once you set up
and start your cluster, run 'pcs status' to get (amongs other info) the
node names. In your configuration, they should be srv1cr1 and srv2cr1.
Regards,
Tomas
__ __
Thank you!
_______________________________________________
Users mailing list: [email protected]
https://lists.clusterlabs.org/mailman/listinfo/users
Project Home: http://www.clusterlabs.org
Getting started: http://www.clusterlabs.org/doc/Cluster_from_Scratch.pdf
Bugs: http://bugs.clusterlabs.org
_______________________________________________
Users mailing list: [email protected]
https://lists.clusterlabs.org/mailman/listinfo/users
Project Home: http://www.clusterlabs.org
Getting started: http://www.clusterlabs.org/doc/Cluster_from_Scratch.pdf
Bugs: http://bugs.clusterlabs.org
