here's the debug output from a burn, fwiw: System ----------------------- K3b Version: 1.0.3
KDE Version: 3.5.8 QT Version: 3.3.7 Kernel: 2.6.22-14-generic Devices ----------------------- TSSTcorp DVD+-RW TS-L632D DE03 (/dev/scd0, ) [CD-R, CD-RW, CD-ROM, DVD-ROM, DVD-R, DVD-RW, DVD-R DL, DVD+R, DVD+RW, DVD+R DL] [DVD-ROM, DVD-R Sequential, DVD-RW Restricted Overwrite, DVD-RW Sequential, DVD+RW, DVD+R, DVD+R Dual Layer, CD-ROM, CD-R, CD-RW] [SAO, TAO, RAW, SAO/R96P, SAO/R96R, RAW/R16, RAW/R96P, RAW/R96R, Restricted Overwrite, Layer Jump] Used versions ----------------------- cdrecord: 1.1.6 cdrecord ----------------------- /usr/bin/wodim: Operation not permitted. Warning: Cannot raise RLIMIT_MEMLOCK limits.scsidev: '/dev/scd0' devname: '/dev/scd0' scsibus: -2 target: -2 lun: -2 Linux sg driver version: 3.5.27 Wodim version: 1.1.6 SCSI buffer size: 64512 Beginning DMA speed test. Set CDR_NODMATEST environment variable if device communication breaks or freezes immediately after that. TOC Type: 1 = CD-ROM Driveropts: 'burnfree' Device type : Removable CD-ROM Version : 5 Response Format: 2 Capabilities : Vendor_info : 'TSSTcorp' Identification : 'DVD+-RW TS-L632D' Revision : 'DE03' Device seems to be: Generic mmc2 DVD-R/DVD-RW. Current: 0x0009 (CD-R) Profile: 0x002B (DVD+R/DL) Profile: 0x001B (DVD+R) Profile: 0x001A (DVD+RW) Profile: 0x0014 (DVD-RW sequential recording) Profile: 0x0013 (DVD-RW restricted overwrite) Profile: 0x0011 (DVD-R sequential recording) Profile: 0x0010 (DVD-ROM) Profile: 0x000A (CD-RW) Profile: 0x0009 (CD-R) (current) Profile: 0x0008 (CD-ROM) Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr). Driver flags : MMC-3 SWABAUDIO BURNFREE Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R Drive buf size : 1633280 = 1595 KB FIFO size : 12582912 = 12288 KB Speed set to 4234 KB/s Track 01: data 697 MB Total size: 800 MB (79:21.33) = 357100 sectors Lout start: 801 MB (79:23/25) = 357100 sectors Current Secsize: 2048 ATIP info from disk: Indicated writing power: 4 Is unrestricted Is not erasable Disk sub type: Medium Type A, low Beta category (A-) (2) ATIP start of lead in: -11634 (97:26/66) ATIP start of lead out: 359849 (79:59/74) Disk type: Short strategy type (Phthalocyanine or similar) Manuf. index: 3 Manufacturer: CMC Magnetics Corporation Blocks total: 359849 Blocks current: 359849 Blocks remaining: 2749 Starting to write CD/DVD at speed 24.0 in real SAO mode for single session. Last chance to quit, starting real write in 2 seconds. 1 seconds. 0 seconds. Operation starts. Waiting for reader process to fill input buffer ... input buffer ready. Performing OPC... Sending CUE sheet... Writing pregap for track 1 at -150 Starting new track at sector: 0 Track 01: 0 of 697 MB written. Track 01: 1 of 697 MB written (fifo 100%) [buf 100%] 0.4x. < snipped > Track 01: 697 of 697 MB written (fifo 100%) [buf 100%] 25.4x. Track 01: Total bytes read/written: 731340800/731340800 (357100 sectors). Writing time: 285.183s Average write speed 17.1x. Min drive buffer fill was 97% Fixating... Fixating time: 24.706s /usr/bin/wodim: fifo had 11520 puts and 11520 gets. /usr/bin/wodim: fifo was 0 times empty and 10622 times full, min fill was 97%. BURN-Free was never needed. cdrecord command: ----------------------- /usr/bin/wodim -v gracetime=2 dev=/dev/scd0 speed=24 -dao driveropts=burnfree -overburn -data -tsize=357100s - -- k3b error when writing and verifying DVDs using slimline drive https://bugs.launchpad.net/bugs/114758 You received this bug notification because you are a member of Kubuntu Team, which is a bug contact for k3b in ubuntu. -- kubuntu-bugs mailing list [EMAIL PROTECTED] https://lists.ubuntu.com/mailman/listinfo/kubuntu-bugs