Public bug reported:
console-conf currently does not dynamically detect if ethernet cables get
plugged in.
if you forget to plug your board in you are not able to configure the network
properly ...
rebooting the board will never clear the state of the snapd firstboot job, it
runs on every boot and will fail on every boot, leaving you with a broken state
and snap list will report no snaps installed.
the only way out of this is to freshly dd the image and start over with
the ethernet cable plugged in before boot.
there are two bugs here, snapd's firstboot job should never go into this
state and console-conf should auto-detect plug events and dynamically
update the UI to allow configuring the interface without forcing a
reboot (this is partially bug 1623897)
** Affects: snappy
Importance: Undecided
Status: New
** Affects: snapd (Ubuntu)
Importance: Undecided
Status: New
** Affects: subiquity (Ubuntu)
Importance: Undecided
Status: New
** Also affects: snapd (Ubuntu)
Importance: Undecided
Status: New
** Also affects: subiquity (Ubuntu)
Importance: Undecided
Status: New
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/1624329
Title:
snapd firstboot setup fails constantly when rebooting before console-
conf has finished
To manage notifications about this bug go to:
https://bugs.launchpad.net/snappy/+bug/1624329/+subscriptions
--
ubuntu-bugs mailing list
[email protected]
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
