It works OK too:
[ 2.551240] sky2 driver version 1.22
[ 2.551323] sky2 0000:02:00.0: enabling device (0000 -> 0003)
[ 2.551348] sky2 0000:02:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[ 2.551376] sky2 0000:02:00.0: setting latency timer to 64
[ 2.551429] sky2 0000:02:00.0: Yukon-2 FE+ chip revision 0
[ 2.551626] sky2 0000:02:00.0: irq 26 for MSI/MSI-X
[ 2.553698] sky2 eth0: addr 00:24:81:4e:c6:e6
[ 20.357667] sky2 eth1: enabling interface
[ 23.184510] sky2 eth1: Link is up at 100 Mbps, full duplex, flow control both
However, the sky2 module reports an error when booting on batteries
after shutdown, but this is related to bug 297263, not this one AFAICS:
[ 2.581071] sky2 driver version 1.22
[ 2.581169] sky2 0000:02:00.0: enabling device (0000 -> 0003)
[ 2.581195] sky2 0000:02:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[ 2.581223] sky2 0000:02:00.0: setting latency timer to 64
[ 2.581264] sky2 0000:02:00.0: unsupported chip type 0xff
[ 2.581293] sky2 0000:02:00.0: PCI INT A disabled
[ 2.581311] sky2: probe of 0000:02:00.0 failed with error -95
** Changed in: linux (Ubuntu)
Status: Incomplete => New
--
Marvell 88E8040 PCI-E Fast Ethernet Controller not working in karmic
https://bugs.launchpad.net/bugs/384403
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
ubuntu-bugs mailing list
ubuntu-bugs@lists.ubuntu.com
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
