** Description changed:
+ SRU Justification:
+
+ Impact: This bug causes SiS 190/191 on ASUS P5SD2-VM does not detect link
status
+ and does not send traffic
+
+ Fix: This patch that is upstream since 2.6.28 (and is contained in
+ Jaunty)
+
+ Testcase: Make sure that SiS 190/191 detects link status and sends
+ traffic
+
+ ---
+
I have a motherboard ASUS P5SD2-VM (E3464) with SIS968 chipset and
SIS190/191 10/100 ethernet controler. Using ubuntu 8.04.1-server (kernel
2.6.24-9) this device is found by kernel but dont send trafic.
Clables and connections are checked and orange led indicating 100Mbps
are on.
What to do? it´s a problem with some configuration or is a driver
problem?
more information:
uname -a
Linux ubuntu 2.6.24-19-server #1 SMP Wed Jun 18 15:18:00 UTC 2008 i686
GNU/Linux
modproble sis190 && dmes | tail -n 11
[ 259.833889] sis190: no version for "struct_module" found: kernel tainted.
[ 259.834785] sis190 Gigabit Ethernet driver 1.2 loaded.
[ 259.834823] ACPI: PCI Interrupt 0000:00:04.0[A] -> GSI 19 (level, low) ->
IRQ 21
[ 259.834837] PCI: Setting latency timer of device 0000:00:04.0 to 64
[ 259.834846] 0000:00:04.0: Read MAC address from EEPROM
[ 259.834847] 0000:00:04.0: Error EEPROM read 0.
[ 259.834850] 0000:00:04.0: Read MAC address from APC.
[ 259.952632] 0000:00:04.0: Unknown PHY trans at address 0x1 phy->id[0]=
0x4d phy->id[1]=0xd021.
[ 261.310970] 0000:00:04.0: SiS 191 PCI Gigabit Ethernet adapter at f920ac00
(IRQ: 21), 00:1e:8c:a9:f9:9d
[ 261.310974] eth0: GMII mode.
[ 261.310977] eth0: Enabling Auto-negotiation.
/sbin/ifconfig eth0
eth0 Link encap:Ethernet HWaddr 00:1e:8c:a9:f9:9d
inet addr:xxx.xxx.xxx.xxx Bcast:xxx.xxx.xxx.255 Mask:255.255.255.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:5 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:300 (300.0 B) TX bytes:0 (0.0 B)
Interrupt:21 Base address:0xdead
note: pc recieves packets but dont send.
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
Current message level: 0x00000037 (55)
Link detected: no
note: Link detected: no
lshw -C network
*-network:0
description: Ethernet interface
product: 191 Gigabit Ethernet Adapter
vendor: Silicon Integrated Systems [SiS]
physical id: 4
bus info: p...@0000:00:04.0
logical name: eth0
version: 02
serial: 00:1e:8c:a9:f9:9d
size: 100MB/s
capacity: 100MB/s
width: 32 bits
clock: 33MHz
capabilities: pm bus_master cap_list ethernet physical tp mii 10bt
10bt-fd 100bt 100bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=sis190
driverversion=1.2 duplex=full ip=xxx.xxx.xxx.xxx latency=0 link=no
module=sis190 multicast=yes port=MII speed=100MB/s
mii-diag eth0 --force
Basic registers of MII PHY #0: ffff ffff ffff ffff ffff ffff ffff ffff.
No MII transceiver present!.
The autonegotiated capability is 03e0.
The autonegotiated media type is 100baseTx-FD.
Basic mode control register 0xffff: Auto-negotiation enabled.
Internal Collision-Test enabled!
Restarted auto-negotiation in progress!
Transceiver isolated from the MII!
Transceiver powered down!
Transceiver in loopback mode!
Transceiver currently being reset!
Basic mode status register 0xffff ... ffff.
Link status: established.
Remote fault detected!
*** Link Jabber! ***
Your link partner advertised ffff: Flow-control 100baseT4 100baseTx-FD
100baseTx 10baseT-FD 10baseT, w/ 802.3X flow control.
End of basic transceiver information.
--
SiS 190/191 on ASUS P5SD2-VM dont detect link status / dont send traffic
https://bugs.launchpad.net/bugs/247889
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
ubuntu-bugs mailing list
ubuntu-bugs@lists.ubuntu.com
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
