Public bug reported:
The ath9k module appears to load fine. But I'm unable to see any
wireless networks by scanning and I can't get a dhcp lease.
[EMAIL PROTECTED]:~# lsb_release -rd
Description: Ubuntu intrepid (development branch)
Release: 8.10
[EMAIL PROTECTED]:~# cat /proc/version
Linux version 2.6.27-3-generic ([EMAIL PROTECTED]) (gcc version 4.3.2 (Ubuntu
4.3.2-1ubuntu6) ) #1 SMP Wed Sep 10 16:02:00 UTC 2008
[EMAIL PROTECTED]:~# ifconfig
eth0 Link encap:Ethernet HWaddr foo
inet addr:192.168.11.8 Bcast:192.168.11.255 Mask:255.255.255.0
inet6 addr:bar/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:32090 errors:0 dropped:3988762564 overruns:0 frame:0
TX packets:17840 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:47008544 (47.0 MB) TX bytes:1653147 (1.6 MB)
Interrupt:218 Base address:0xe000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:2352 errors:0 dropped:0 overruns:0 frame:0
TX packets:2352 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:117600 (117.6 KB) TX bytes:117600 (117.6 KB)
wlan0 Link encap:Ethernet HWaddr aa:bb:cc:dd:ee:ff
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
wmaster0 Link encap:UNSPEC HWaddr
AA-BB-CC-DD-EE-FF-00-00-00-00-00-00-00-00-00-00
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
[EMAIL PROTECTED]:~# iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wmaster0 no wireless extensions.
wlan0 IEEE 802.11bgn ESSID:""
Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
Tx-Power=27 dBm
Retry min limit:7 RTS thr:off Fragment thr=2352 B
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
[EMAIL PROTECTED]:~# iwconfig wlan0 essid myessid
[EMAIL PROTECTED]:~# iwconfig wlan0 key 1 s:aabbccddeeff0
[EMAIL PROTECTED]:~# iwconfig wlan0 ap 00:11:22:33:44:55
[EMAIL PROTECTED]:~# dhclient wlan0
Internet Systems Consortium DHCP Client V3.1.1
Copyright 2004-2008 Internet Systems Consortium.
All rights reserved.
For info, please visit http://www.isc.org/sw/dhcp/
wmaster0: unknown hardware address type 801
wmaster0: unknown hardware address type 801
Listening on LPF/wlan0/aa:bb:cc:dd:ee:ff
Sending on LPF/wlan0/aa:bb:cc:dd:ee:ff
Sending on Socket/fallback
DHCPDISCOVER on wlan0 to 255.255.255.255 port 67 interval 7
DHCPDISCOVER on wlan0 to 255.255.255.255 port 67 interval 8
DHCPDISCOVER on wlan0 to 255.255.255.255 port 67 interval 18
DHCPDISCOVER on wlan0 to 255.255.255.255 port 67 interval 15
DHCPDISCOVER on wlan0 to 255.255.255.255 port 67 interval 13
No DHCPOFFERS received.
No working leases in persistent database - sleeping.
[EMAIL PROTECTED]:~# iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wmaster0 no wireless extensions.
wlan0 IEEE 802.11bgn ESSID:"myessid"
Mode:Managed Frequency:2.432 GHz Access Point: Not-Associated
Tx-Power=27 dBm
Retry min limit:7 RTS thr:off Fragment thr=2352 B
Encryption key:6161-6262-6363-6464-6565-6666-30 Security mode:open
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
[EMAIL PROTECTED]:~# iwlist wlan0 scan
wlan0 No scan results
I tried broadcasting my ssid and turning off WEP. Same results.
Matching iwconfig wlan0 chan 5 to my router's current channel did not
help.
My wireless router doesn't report any log activity.
The wireless LED on my laptop is on. Fn+F2 appears like it is supposed
to turn this off an on but has no effect.
I successfully connected to this router with this laptop when it had
Vista on it.
03:00.0 Network controller: Atheros Communications Inc. Device 002a (rev 01)
Subsystem: Device 1a3b:1067
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort-
<MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 17
Region 0: Memory at fdff0000 (64-bit, non-prefetchable) [size=64K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1+ D2- AuxCurrent=375mA
PME(D0+,D1+,D2-,D3hot+,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [50] Message Signalled Interrupts: Mask- 64bit- Queue=0/0
Enable-
Address: 00000000 Data: 0000
Capabilities: [60] Express (v1) Legacy Endpoint, MSI 00
DevCap: MaxPayload 128 bytes, PhantFunc 0, Latency L0s <512ns,
L1 <64us
ExtTag- AttnBtn- AttnInd- PwrInd- RBE- FLReset-
DevCtl: Report errors: Correctable- Non-Fatal- Fatal-
Unsupported-
RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop-
MaxPayload 128 bytes, MaxReadReq 512 bytes
DevSta: CorrErr- UncorrErr+ FatalErr- UnsuppReq+ AuxPwr-
TransPend-
LnkCap: Port #0, Speed 2.5GT/s, Width x1, ASPM unknown, Latency
L0 <512ns, L1 <64us
ClockPM- Suprise- LLActRep- BwNot-
LnkCtl: ASPM L1 Enabled; RCB 128 bytes Disabled- Retrain-
CommClk+
ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt-
LnkSta: Speed 2.5GT/s, Width x1, TrErr- Train- SlotClk+
DLActive- BWMgmt- ABWMgmt-
Capabilities: [90] MSI-X: Enable- Mask- TabSize=1
Vector table: BAR=0 offset=00000000
PBA: BAR=0 offset=00000000
Capabilities: [100] Advanced Error Reporting <?>
Capabilities: [140] Virtual Channel <?>
Capabilities: [160] Device Serial Number 00-00-00-00-00-00-00-00
Kernel driver in use: ath9k
Kernel modules: ath9k
[EMAIL PROTECTED]:~# grep -P 'ath9k|phy0' /var/log/dmesg
[ 15.642168] ath9k: 0.1
[ 15.658303] ath9k 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[ 15.658315] ath9k 0000:03:00.0: setting latency timer to 64
[ 16.347609] phy0: Selected rate control algorithm 'ath9k_rate_control'
[ 16.521823] phy0: Atheros 9280: mem=0xf8ba0000, irq=17
ProblemType: Bug
Architecture: i386
DistroRelease: Ubuntu 8.10
NonfreeKernelModules: nvidia
Package: linux-image-2.6.27-3-generic 2.6.27-3.4 [modified:
lib/modules/2.6.27-3-generic/modules.pcimap
lib/modules/2.6.27-3-generic/modules.dep
lib/modules/2.6.27-3-generic/modules.ieee1394map
lib/modules/2.6.27-3-generic/modules.usbmap
lib/modules/2.6.27-3-generic/modules.isapnpmap
lib/modules/2.6.27-3-generic/modules.inputmap
lib/modules/2.6.27-3-generic/modules.seriomap
lib/modules/2.6.27-3-generic/modules.alias
lib/modules/2.6.27-3-generic/modules.symbols]
ProcCmdLine: root=UUID=d048706d-1e80-47b5-9f7a-ddc2baaf7c79 ro quiet splash
ProcEnviron:
PATH=/usr/local/sbin:/usr/local/bin:/usr/sbin:/usr/bin:/sbin:/bin:/usr/games
LANG=en_US.UTF-8
SHELL=/bin/bash
ProcVersionSignature: Ubuntu 2.6.27-3.4-generic
SourcePackage: linux
** Affects: linux (Ubuntu)
Importance: Undecided
Status: New
** Tags: apport-bug
--
ath9k wireless not working with AR9280
https://bugs.launchpad.net/bugs/270748
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
ubuntu-bugs mailing list
ubuntu-bugs@lists.ubuntu.com
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
