Hi Marek, Thanks for the review, I'll get back to it asap. In the meantime please take note of my new e-mail address.
Best regards, Philip Oberfichtner On Wed, Dec 31, 2025 at 10:27:44PM +0100, Marek Vasut wrote: > On 11/10/25 10:12 AM, Philip Oberfichtner wrote: > > [...] > > > diff --git a/common/spl/Kconfig b/common/spl/Kconfig > > index 8dade2b501e..97c7bfdad47 100644 > > --- a/common/spl/Kconfig > > +++ b/common/spl/Kconfig > > @@ -36,19 +36,33 @@ config SPL_FRAMEWORK_BOARD_INIT_F > > - initialize the serial (preloader_console_init) > > Unless you want to provide your own board_init_f, you should say Y. > > +config HAS_SPL_SIZE_LIMIT > > + bool "Enable size limit check for the SPL image" > > + depends on !COMPILE_TEST > > + depends on SPL > > + default y if ARCH_MX6 > > + default y if ARCH_MVEBU && ARMADA_32BIT > > + default y if ARMADA_38X > > + default y if K3_DM_FW > > K3_DM_FW is some driver, what you likely want here is: > > default y if ARCH_K3 && CPU_V7R && !SOC_K3_AM642 && !SOC_K3_AM654 && > !CLK_TI_SCI && !TI_SCI_POWER_DOMAIN > > But it seems am64x_evm_r5_defconfig below enables HAS_SPL_SIZE_LIMIT too , > so likely remove !SOC_K3_AM642 from the above, which will allow you to > reduce the amount of configs/ file changes. > > > + default y if SOC_K3_AM625 > > + default y if SOC_MT7621 > > + default y if TARGET_SOCFPGA_GEN5 > > You could also add Xilinx Zynq/ZynqMP into the defaults here, which will > further reduce the configs/ file changes. > > The rest looks fine, thanks !
