Hi Fabio,
On 07.07.25 03:18, Fabio Estevam wrote:
Hi,
I'm trying to enable bootcount support on the imx6ul-evk board like this:
--- a/configs/mx6ul_14x14_evk_defconfig
+++ b/configs/mx6ul_14x14_evk_defconfig
@@ -110,3 +110,8 @@ CONFIG_SPLASH_SCREEN=y
CONFIG_SPLASH_SCREEN_ALIGN=y
CONFIG_BMP_16BPP=y
CONFIG_IMX_WATCHDOG=y
+CONFIG_SYS_BOOTCOUNT_ADDR=0x020B0068
+CONFIG_SYS_BOOTCOUNT_SINGLEWORD=y
+CONFIG_BOOTCOUNT_LIMIT=y
+CONFIG_SYS_BOOTCOUNT_MAGIC=0xB0C4000
+CONFIG_SYS_BOOTCOUNT_BE=y
However, the 'bootcount' variable does not increment after a 'reset' command:
=> print bootcount
bootcount=1
Has anyone managed to get bootcount working on it?MX6UL?
Have you checked if CONFIG_SYS_BOOTCOUNT_ADDR address is stable over
reset? May someone overwrites it...
I had it working on imx6ull
CONFIG_BOOTCOUNT_BOOTLIMIT=3
CONFIG_SYS_BOOTCOUNT_ADDR=0x20d8024
CONFIG_SYS_BOOTCOUNT_SINGLEWORD=y
CONFIG_BOOTCOUNT_LIMIT=y
I did not needed
> +CONFIG_SYS_BOOTCOUNT_MAGIC=0xB0C4000
> +CONFIG_SYS_BOOTCOUNT_BE=y
but may because I have an older base...
Hmm.. your register seems fine ... I read in RM:
"""
For backward compatibility with earlier
versions of SNVS LPGPR0 is aliased at its original offset of 68h.The GPR will be
automatically zeroized when a tamper event occurs, unless GPR zeroization is
disabled
via the GPR_Z_DIS bit in the LP Control Register.
"""
May try 0x20b00090 ... just a try...
May tamper event occurs? And the register is in "low power domain" ... may
there is a problem... so no real idea here from my side, just speculation...
bye,
Heiko
--
DENX Software Engineering GmbH, Managing Director: Johanna Denk, Tabea Lutz
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-52 Fax: +49-8142-66989-80 Email: [email protected]
