Has this been tested on all variants of the chip?
On Sun, Jan 17, 2010 at 07:40:29PM +0000, Tom Murphy wrote:
> Hi,
>
> I'd like to point out that Roland Dreier's patch as detailed
> here: http://www.mail-archive.com/m...@openbsd.org/msg83528.html
> Works great on my little Soekris 5501 with a RT2661. (dmesg attached
> to end of this email.)
>
> I do still get the odd wireless drop for 15-20 seconds, but it
> no longer brings up the OACTIVE flag on ral0 and it doesn't make
> the system completely freeze (no way of getting a dump, have to
> hard reset.)
>
> I emailed damien@ on December 1st and got no response. The author
> of the patch has expressed his frustration at being able to contact
> a developer to get this committed.
>
> I would be more than happy to do testing. Feel free to contact me..
> I know it's hard to test all hardware devices when there is a lack of them.
>
> Regards,
>
> Tom
>
> (kernel was compiled by me, with aforementioned patch above, and is GENERIC)
>
> OpenBSD 4.6-current (GENERIC) #2: Fri Nov 27 12:20:04 GMT 2009
> r...@pertho.net:/usr/src/sys/arch/i386/compile/GENERIC
> cpu0: Geode(TM) Integrated Processor by AMD PCS ("AuthenticAMD" 586-class)
> 500 MHz
> cpu0: FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CFLUSH,MMX
> real mem = 536440832 (511MB)
> avail mem = 511152128 (487MB)
> mainbus0 at root
> bios0 at mainbus0: AT/286+ BIOS, date 20/80/26, BIOS32 rev. 0 @ 0xfac40
> pcibios0 at bios0: rev 2.0 @ 0xf0000/0x10000
> pcibios0: pcibios_get_intr_routing - function not supported
> pcibios0: PCI IRQ Routing information unavailable.
> pcibios0: PCI bus #0 is the last bus
> bios0: ROM list: 0xc8000/0xa800
> cpu0 at mainbus0: (uniprocessor)
> amdmsr0 at mainbus0
> pci0 at mainbus0 bus 0: configuration mode 1 (bios)
> io address conflict 0x6100/0x100
> io address conflict 0x6200/0x200
> pchb0 at pci0 dev 1 function 0 "AMD Geode LX" rev 0x33
> glxsb0 at pci0 dev 1 function 2 "AMD Geode LX Crypto" rev 0x00: RNG AES
> vr0 at pci0 dev 6 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 11, address
> 00:00:24:cb:a6:64
> ukphy0 at vr0 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI
> 0x004063, model 0x0034
> vr1 at pci0 dev 7 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 5, address
> 00:00:24:cb:a6:65
> ukphy1 at vr1 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI
> 0x004063, model 0x0034
> vr2 at pci0 dev 8 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 9, address
> 00:00:24:cb:a6:66
> ukphy2 at vr2 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI
> 0x004063, model 0x0034
> vr3 at pci0 dev 9 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 12, address
> 00:00:24:cb:a6:67
> ukphy3 at vr3 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI
> 0x004063, model 0x0034
> ral0 at pci0 dev 14 function 0 "Ralink RT2661" rev 0x00: irq 10, address
> 00:14:85:d5:39:bb
> ral0: MAC/BBP RT2661D, RF RT2529 (MIMO XR)
> glxpcib0 at pci0 dev 20 function 0 "AMD CS5536 ISA" rev 0x03: rev 0, 32-bit
> 3579545Hz timer, watchdog, gpio
> gpio0 at glxpcib0: 32 pins
> pciide0 at pci0 dev 20 function 2 "AMD CS5536 IDE" rev 0x01: DMA, channel 0
> wired to compatibility, channel 1 wired to compatibility
> wd0 at pciide0 channel 0 drive 1: <WDC WD1200BEVS-00VAT0>
> wd0: 16-sector PIO, LBA48, 114473MB, 234441648 sectors
> wd0(pciide0:0:1): using PIO mode 4, Ultra-DMA mode 2
> pciide0: channel 1 ignored (disabled)
> ohci0 at pci0 dev 21 function 0 "AMD CS5536 USB" rev 0x02: irq 15, version
> 1.0, legacy support
> ehci0 at pci0 dev 21 function 1 "AMD CS5536 USB" rev 0x02: irq 15
> usb0 at ehci0: USB revision 2.0
> uhub0 at usb0 "AMD EHCI root hub" rev 2.00/1.00 addr 1
> isa0 at glxpcib0
> isadma0 at isa0
> com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
> com0: console
> com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
> pckbc0 at isa0 port 0x60/5
> pcppi0 at isa0 port 0x61
> midi0 at pcppi0: <PC speaker>
> spkr0 at pcppi0
> nsclpcsio0 at isa0 port 0x2e/2: NSC PC87366 rev 9: GPIO VLM TMS
> gpio1 at nsclpcsio0: 29 pins
> npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
> usb1 at ohci0: USB revision 1.0
> uhub1 at usb1 "AMD OHCI root hub" rev 1.00/1.00 addr 1
> biomask e1c7 netmask ffe7 ttymask ffff
> mtrr: K6-family MTRR support (2 registers)
> vscsi0 at root
> scsibus0 at vscsi0: 256 targets
> softraid0 at root
> root on wd0a swap on wd0b dump on wd0b
