On Wed, 10.07.13 11:26, Dmt Ops ([email protected]) wrote:
> Hey all,
>
> I'm starting upgrades to old production servers to newer 64-bit Linux that
> runs systemd >= v195.
>
> Serial consoles are always my 1st step. Before upgrade it worked great.
>
> After upgrade, with the new systemd-based config, I'm not having much luck
> so far.
Note that systemd will actually automatically spawn a serial getty on
the serial port kernel logging is directed to. Normally you should not
need to do anything.
> I configured the grub conf:
>
> serial --unit=0 --speed=57600 --word=8 --parity=no --stop=1
> terminal --timeout=3 serial console
> title PRODUCTION
> root (hd0,0)
> kernel /vmlinuz root=/dev/sd1a noresume showopts x11failsafe vga=0x31a
> console=tty0 console=com1,vga
^^^^^^^^
That doesn't look right.
> With that setup I get nothing out the serial port. I probably have the
> grub cmd line wrong for using with systemd. I could use some help getting
> this untangled.
Maybe the baud rate isn't right? Note that [email protected] will
try to reuse whatever was initialized by the kernel, hence make sure to
configure the right parameters on the kernel console and you should be
fine.
Lennart
--
Lennart Poettering - Red Hat, Inc.
_______________________________________________
systemd-devel mailing list
[email protected]
http://lists.freedesktop.org/mailman/listinfo/systemd-devel
