Hi elmarco:
I met a problem with usbclerk.
First, I plugged in two same usb device. Then I used usbclerk to change the
driver to winusb.
I sent only one message which caused both the drivers changed.
After that, I use usbclerk to remove the winusb driver. The first device
driver could be restored properly, but the second one was not so lucky:
if (!SetupDiBuildDriverInfoList(devs, dev_info, SPDIT_CLASSDRIVER)) {
vd_printf("Cannot build driver info list: %ld", GetLastError());
return false;
}
SetupDiBuildDriverInfoList returned 2 and the driver didn't change.
Another scenario:
I plugged in one device, and changed the driver to winusb. Then the second
one plugged in. The usbclerk did not work well. Since it found there was
already a device with the same vid&pid installed with winusb.
Do you have any solutions?
Thx!
_______________________________________________
Spice-devel mailing list
[email protected]
http://lists.freedesktop.org/mailman/listinfo/spice-devel
