Looks like I've been reinventing the wheel. After some searching, I see
others have gotten m0n0wall to work on the IP380 but have ran into the
same problem with the MAC address. It seems as though the eeproms that
store the MAC address aren't on the system board. I had a couple of the
eeprom
On Sat, Aug 24, 2013 at 3:00 PM, Chris Cappuccio wrote:
The errors you got are due to errors reported by the IDE controller
back to the pciide driver. That's a layer (or two) lower than the
filesystem itself. If moving the drive around fixed it, perhaps there
was a poor connection somewhere?
I finally got it to boot successfully. Not sure what was up with the
hard drive errors. Maybe the file system wasn't clean? After I put
the drive in the laptop and let it boot Ok, it's been booting Ok in the
IP380. I'll see if I can get the network ports to work later today.
Thanks again
On Sat, Aug 24, 2013 at 11:00 AM, Brynet wrote:
z I meant removing both mappings and then adding a single 1023M mapping,
I
didn't expect it to work with <1M of RAM. ;-)
I figured that out after the fact :)
What is the new panic message? Does it enter ddb>?
The bogus MAC addresses coul
On Sat, Aug 24, 2013 at 10:08 AM, Brynet wrote:
This is likely a problem with the BIOS on the system, the memory map
has
duplicate entries..
You can attempt to manually fix this at boot> using a variation of the
same command used to retreive the mappings:
boot> mach mem =1023M
You can pla
On Fri, Aug 23, 2013 at 11:06 PM, Mike Larkin wrote:
At the boot> prompt, what does "mach mem" show?
-ml
Hi Mike, here's the output from mach mem. It only has 1GB of memory.
Not sure why it's saying the total is 2GB.
Stan
Using drive 0, partition 3.
Loading.
probing: pc0 com0 com1
On Fri, Aug 23, 2013 at 6:04 PM, Ray Percival wrote:
Having worked for Check Point/Nokia.
They wine to great lengths to only make that hardware work with their
Free based OS. I wish you luck but realistically it's not likely.
OpenBSD works just fine on the newer Check Point boxes. They're far
I've been trying to get a more modern OS to run on an ancient Nokia
firewall by loading an OS on the drive in a Dell D610 and moving the
drive to the IP380. So far, I've had little success. I can get FreeBSD
8.1 to work if I disable USB support. That's the only OS I've been able
to get to b
