I run through an Omniview (4-port) with no problems. My office has four of
them total.
Did you swap the cables? My windows machine put out a line down the monitor
where as my Linux does not.
It turns out that some video cards have different effects through the box.
I would try swapping out the
> Monitor: ViewSonic G771
> I used the following Custom settings:
> Non-Interlaced SVGA, 1024x768 @ 60 Hz
> Vertical Sync Range 50-90
using 50-60
fixed this problem on my S3 at 1024x768
tim
--
-
Tim (I don't spell check) Fairchild
Kut
On Sat, 21 Mar 1998, Dave Wreski wrote:
> Make the refresh rate anything but 60 hertz, and the flicker should go
> away. THe tradeoff is the actual speed of the display will be slower.
> Try xvidtune, or Xconfigurator, and hopefully you can fine-tune it.
I have to disagree here. Flicker can b
On 21-Mar-98 Kent R. Frazier wrote:
> I have redhat 4.2 installed using XFree86 and AfterStep 1.0. When I set
> up my video card settings during install I took a very conservative
> route. I am now noticing a slight screen flicker after installing
> AfterStep.
>
> My settings are as follows:
>
