Hi again Francois!
2.6.22-rc7 does suspend-to-disk again ... and the bad news is, the reported
problem (link speed 100 not 1000 after resume from suspend-to-disk) is still
there when using 2.6.22-rc7 with your -rc6 driver patch.
The symptoms are the same as in 2.6.18 with unpatched r8169.
ifdo
Hi again Francois!
> > No NFS but networking or no networking at all ?
>
> Networking in itself was fine and stable, and with seemingly much better
> performance in large file transfers as well.
>
> NFS appeared to be working too, problem was just that workstation and
> server couldn't agree on fi
Hi Francois!
> Peter Missel <[EMAIL PROTECTED]> :
>
> > Unfortunately I couldn't get NFS to work with the updated kernel, so I
> > had to revert to the original from SuSE 10.2.
>
> No NFS but networking or no networking at all ?
Networking in itself was fine
time.
I'll be back.
regards,
Peter
> Peter Missel <[EMAIL PROTECTED]> :
> [...]
>
> > The patch applies without failure; I'm getting a warning during build,
> >
> > CC [M] drivers/net/r8169.o
> > drivers/net/r8169.c: In function ‘rtl8169_start
Bonjour Francois!
> If you feel adventurous, you will find a compile-tested-only patchkit for
> 2.6.21.5 here:
> http://www.fr.zoreil.com/linux/kernel/2.6.x/2.6.21.5
> or:
> http://www.fr.zoreil.com/people/francois/misc/20060630-2.6.21.5-r8169-test.
>patch
>
> The content should be almost the same
Hello Francois!
I have finally gotten round to updating the kernel on this workstation.
It is now on 2.6.21.5 as downloaded from www.kernel.org, built for AMD64.
Unfortunately, the problem is not gone. After suspend-to-disk and resume, link
speed is 100. Unplugging and replugging the cable does
Hi Francois!
Sorry, returning to this issue took me longer than anticipated before I could
return to the issue.
> Hardly: the r8169 driver has been modified by ~40 patches from 2.6.18 to
> now.
>
> There is an ugly hack^W^W quick backport for 2.6.18 at:
> http://www.fr.zoreil.com/people/francois
Hi Francois,
and thanks again for the quick replies.
> > Does this patchset work against kernel 2.6.18, or, better yet, is there a
> > separate source package that lets me build the current driver on this
> > older kernel?
>
> Hardly: the r8169 driver has been modified by ~40 patches from 2.6.18
Hello Francois!
Thanks for the quick reply.
> > Now after resume, the link is working OK but doesn't come back up to
> > normal gigabit operation. ifdown, unloading and reloading the r8169
> > module, and then ifup again fixes it.
> >
> Can you try 2.6.21-rc7 + (either):
> - http://www.fr.zoreil.
Greetings!
I have a SuSE 10.2 64-bit installation that uses a Realtek PCI GbE chip in
D-Link disguise (lspci see below).
While this works rather well after a normal boot sequence, I don't get a
gigabit link after resume from standby or suspend-to-disk.
Entering standby, the link speed goes dow
10 matches
Mail list logo
