On 12.12.2018 23:38, Mask The Truth God wrote:
> Greetings, I have been having problem with my hardware for quite a
> while now and have been trying to figure it out on my own just by
> reading forms and such and I have found a few forms that helped but
> honestly most of them were complete idiots
Mask The Truth God composed on 2018-12-12 18:38 (UTC):
> ...1 8 gb ddr3 ram stick
...
> gigabyte 970a-ud3p...
Using a single RAM stick in a motherboard such as yours that supports dual
channel memory
architecture causes a nearly 50% memtest86 performance penalty compared to
those using two or
f
Greetings, I have been having problem with my hardware for quite a while now
and have been trying to figure it out on my own just by reading forms and such
and I have found a few forms that helped but honestly most of them were
complete idiots so I decided to make my own and explain in depth the
On Sat, 23 Jun 2012 15:03:17 -0500, Richard Owlett wrote:
> Camaleón wrote:
>> On Thu, 21 Jun 2012 10:13:31 -0500, Richard Owlett wrote:
>>
>> (...)
>>
>>> As I write I was doing another test install. It appeared to proceed
>>> normally up until I was instructed to remove the CD. Seems to have
>>>
Camaleón wrote:
On Thu, 21 Jun 2012 10:13:31 -0500, Richard Owlett wrote:
(...)
As I write I was doing another test install. It appeared to proceed
normally up until I was instructed to remove the CD. Seems to have
crashed with a bunch of error message.
Error messages are very important :-)
Hello all,
This is possibly (even probably) offtopic.
We have a very strange problem here with one of our servers:
The box:
A dual PIII 866Mhz, Adaptec 7892 160Mb/s scsi card, IBM 20G drive,
3 Intel EEPro100 nics (82557), 512 Mb RAM (133MHz), GigaByte 6VXDC7 rev
1.0 Mainboard.
This box is our
while its not the same model# as your board i have been using Epox
EP-MVP3G2 and EP-MVP3G5 (same board cept one has 1MB of cache the other
has 2MB) without a problem sofar in linux. well i have a problem with the
system unable to init the framebuffer on newer X servers for my 3Dfx
cards, but i had
On 2000-02-02 12:57:02, aphro wrote:
> it would be helpful to know if the machine has ever been running good
> under another distro/OS or if its a 'new' machine..
Old machine that used to work flawlessly with both Linux and that
other OS. However something went wrong (I suspect heat) and it
star
it would be helpful to know if the machine has ever been running good
under another distro/OS or if its a 'new' machine..
install lm_sensors on the machine for some additional info about the
mainboard like voltage and temp and stuff. i also find running X on the
screen with status monitors is goo
Hi,
My debian (woody, 2.2.14) box is crashing after 24 to 48 hours of
operation. The screen goes black but keeps sync, no network
connectivity.
Tried with two different motherboards (EPox EP-MVP3C) with the same
behavior. Don't have the spare parts to replace the other components
(SCSI card, dr
Hi all,
I am receiving the following message when I try to boot
Debian Linux:
boot:
Loading...
Uncompressing Linux...
crc error
-- System halted
Similarly, Win95 fails to boot, stopping at various stages.
What does the message above mean? Any help would be grea
11 matches
Mail list logo
