Re: eth0: error -110 failure writing Tx descriptor to BAP

2003-06-18 Thread Joel Konkle-Parker
[EMAIL PROTECTED] wrote: Hi, I am getting this wireless error with Linksys WPC11 ver 3 card. What is the easiest way to fix this? I am using auto-detection of hardware that came with Knoppix. This is (mostly) fixed in the 0.13e orinoco drivers from http://ozlabs.org/people/dgibson/dldwd/ You'll

eth0: error -110 failure writing Tx descriptor to BAP

2003-06-18 Thread TyagiAnupam
Hi, I am getting this wireless error with Linksys WPC11 ver 3 card. What is the easiest way to fix this? I am using auto-detection of hardware that came with Knoppix.

Re: strange eth0 error

2000-06-27 Thread Ron Rademaker
I've had similar errors, they dissapeared when I recompiled the kernel (and went from not-modules drivers to modules). Ron On Tue, 27 Jun 2000, David C Ables wrote: > > I have a somewhat unpredictable problem with my network card. it's using > the tulip driver module with potato and kernel 2.2.

strange eth0 error

2000-06-27 Thread David C Ables
I have a somewhat unpredictable problem with my network card. it's using the tulip driver module with potato and kernel 2.2.15. sometimes, without any noticeable pattern yet, after I do ifconfig eth0 192.168.36.1 it will wait a while and then start spitting this out over and over: eth0: Tx hung

eth0 Error Message

2000-05-30 Thread Shane
Hi, I am getting the following error message during the boot process randomly. The motherboard is the Intel CA810 with EEPRO100 network card. Power cycling the system sometimes fixes the problem. eth0: card reports no resources eth0: card reports no RX buffers The system is running the Deb

Re: eth0: error

1998-02-13 Thread Martin Bialasinski
"K.Y.Lo" <[EMAIL PROTECTED]> writes: > Installing module SMC-Ultra. > > Loading device 'eth0' > > smc-ultra.c: No SMC Ultra card (i/o=0x280). > /lib/modules/2.0.29/net/smc-ultra.0: init_module: Device or resource > busy. Did you set the card to io 280 using it's dos setupdisk? (Also check, that

eth0: error

1998-02-13 Thread K.Y.Lo
Hi, I have installed Debian 1.3.1.r6 completely. Setting up the network as I know about DNS, IP number etc.. i find it was hard to setup eth0 but it has an error. Installing module SMC-Ultra. Loading device 'eth0' smc-ultra.c: No SMC Ultra card (i/o=0x280). /lib/modules/2.0.29/net/smc-ultra.0: