On Wed, Apr 10, 2002 at 05:16:47PM -0700, Paul Yeatman wrote:
> Hi, I recently installed a RAID controller on a pc and set up within
> the controller's BIOS an array out of two disks using RAID level 1.
> This all went well. Then I booted the system. The system sees the
> two drives I RAID'd as i
hiya paul
which raid controller ???
- is it supported by your kernel ??
- lots of fun finding the right hw and kernel combo
-
- list of "supported hw raid controllers"
-
http://www.linux-ide.org/chipsets.html
- more fun raid stuff
http://www.1U-Ra
Not sure, but you might try adjusting the bios for HD3 instead of HD1,
depending on your motherboard.
Boot off a dos disk and see if you see 1 full partition.
Basically after you RAID the system the drive should appear to whatever
OS as one drive, but you usually have to give the proper OS driver
3 matches
Mail list logo
