Re: [fixed]New installation problem

1998-08-23 Thread Hamish Moffatt
On Sat, Aug 22, 1998 at 09:28:52PM -0500, Nathan E Norman wrote: > On Sat, 22 Aug 1998, Lazar Fleysher wrote: > > : I have connected the cdrom to the secondary channel as a slave drive and > : everything works. I have hard disk on primary ( master) and no other > : devices are connected to the

Re:[fixed]New installation problem

1998-08-23 Thread Nathan E Norman
On Sat, 22 Aug 1998, Lazar Fleysher wrote: : I have connected the cdrom to the secondary channel as a slave drive and : everything works. I have hard disk on primary ( master) and no other : devices are connected to the controller. This is not a valid configuration - you cannot have an IDE cha

Re:[fixed]New installation problem

1998-08-22 Thread Lazar Fleysher
Hello everyone, Good news and questions: I have connected the cdrom to the secondary channel as a slave drive and everything works. I have hard disk on primary ( master) and no other devices are connected to the controller. Probably bad news (or question). I have noticed that during boot, it ne

Re: New installation problem

1998-08-22 Thread Lazar Fleysher
The messages, that I see are the following ... ide: i82371 PIIX(Triton) onPCI bus 0 function 57 ide0: BM-DMA at 0x3000-0x3007 ide1: BM-DMA at 0x3008-0x300f hda: Maxtor 82559A4,2441MB w/256kB Cache, CHS=628/128/63, DMA hdb: DF7910C(-D0161 ), ATAPI CDROM drive The cdrom is connect

Re: New installation problem

1998-08-22 Thread Ole J. Tetlie
*-Lazar Fleysher <[EMAIL PROTECTED]> | | Thank you for your reply, but I think I have to make some clarifications: | | I do not have a Debian CD, I downloaded the base system from the net, and | install everything from hard disk. The CD-ROM device is detected, but the | system hangs just after tha

Re: New installation problem

1998-08-22 Thread Lazar Fleysher
Thank you for your reply, but I think I have to make some clarifications: I do not have a Debian CD, I downloaded the base system from the net, and install everything from hard disk. The CD-ROM device is detected, but the system hangs just after that (well, I have tryed to wait for 5 min, maybe it

Re: New installation problem

1998-08-22 Thread Pann McCuaig
On Sat, Aug 22, 1998 at 02:39:16PM -0700, Lazar Fleysher wrote: > Hello everyone, > > I just downloaded hamm distribution and when I try to install it, the > system lock after detecting IDE CD-ROM. (If I disconnect the CD it works > fine, but then again, I can not boot with CD connected. > Any id

New installation problem

1998-08-22 Thread Lazar Fleysher
Hello everyone, I just downloaded hamm distribution and when I try to install it, the system lock after detecting IDE CD-ROM. (If I disconnect the CD it works fine, but then again, I can not boot with CD connected. Any ideas of how to overcome the problem? Thank you, Lazar