On Tue, Dec 03, 2002 at 12:07:01PM -0500, Mike Mccabe wrote:
>
> I'm looking to install lirc on Redhat 8.0 and in order to use my
> serial port receiver (Packard Bell) I need to use setserial which is
> located in one of the redhat init scripts. Does anyone know the
> location of the setserial configuration so I can assign that serial
> port to lirc.
> Thanks
> Mike
Allow me to be picky....
setserial is not LOCATED IN one of the Red Hat init scripts, but it
is USED by one of them.... there is a difference.
Take a look at /etc/rc.d/rc.serial, or /etc/rc.d/rc.local.
Also take a look at 'man setserial'.
If you don't have a /etc/rc.d/rc.serial, just add the appropriate
command (gleaned from the above reading) to /etc/rc.d/rc.local
--
---- Fred Smith -- [EMAIL PROTECTED] -----------------------------
The eyes of the Lord are everywhere,
keeping watch on the wicked and the good.
----------------------------- Proverbs 15:3 (niv) -----------------------------
--
redhat-list mailing list
unsubscribe mailto:[EMAIL PROTECTED]?subject=unsubscribe
https://listman.redhat.com/mailman/listinfo/redhat-list
