Hi, I have two Linux Red Hat Linux Servers running on 7.3 version. Each server has one Cyclades multi-serial attached.
I have one serial cable that connect one serial port of cyclades on both server. The serial cable is ok and is designed do use software flow control (xon/xoff). The problem is: The stty on boths sides are correct set up (to use xon/xof flow control) and the serial cable also is ok but sometimes I lost information because the flow control. It seems the flow control by software (xon/xoff) are not working ok. It seems that the seial port of cyclades on Linux works ok when it receices a xon/xoff signal but it doens't send a corret signal control when its buffer is almost full, then some data are lost. Is it make sense ? Is there any other parameter to set up to allow correct flow control by software (xon/xoff) ? One important information: If I use the cpu (on board) serial port (instend of cyclades seril port) everything works fine. Thanks, Leandro J. Kohler Support Informática Ltda -- redhat-list mailing list unsubscribe mailto:[EMAIL PROTECTED]?subject=unsubscribe https://listman.redhat.com/mailman/listinfo/redhat-list
