Hi. I-ve just installed a secondary NIC. I was promped from my redhat 7.2 if I want to migrate the settings from my first eth0 card which I answered yes to.So all works fine. My old etho has become eth1 and my new realtech 8139 has become eth0. I want etho to connect to my adsl modem and eth1 to the hub for my subnet. Now the question is. It was always nessassary to perform a modprobe on my old card 3c509 before I found out I could add this line in rc.local. But now I try to perform a modprobe at my new rtl8139, but the module was not found. The question is if I now had to perform a modprobe to that card after I now have rebooted to get internet working, or is this automaticly done when I migrated the card. If I had to modprobe then I suppose I must compile the driver that was supported by the card?
===== Investigating the Norwegain 4.th Secret Service The multiheaded animal. http://hjem.sol.no/altiett/knut_ove_hauge_kuren.html ______________________________________________________ Sjekk snørapporter... fra 500 ski-destinasjoner i Europa på http://no.snow.yahoo.com/ _______________________________________________ Redhat-list mailing list [EMAIL PROTECTED] https://listman.redhat.com/mailman/listinfo/redhat-list
