Hi,
I think you can choose the options in the filter choices when
you set up your printer so you would setup one spool with dublex
say 2200duplex and one as 2200single. If you want to send your
own escape sequences you really need to setup a raw spool without
the filter or with one of your own creation. If you send a command
to the printer before the job usually the first part of the job
will clear the printer setting it back to defaults. The printer
that is first in print.caps is the default printer
Good luck
Linda Hanigan
On Fri, 1 Mar 2002, Henrik Schmiediche wrote:
>
> Hello,
> how do I figure out what printer options are available for a given printer?
> I installed a LaserJet 2200D on a RH 7.2 today. It printed duplex out of the
> box in that was easy enough to change by default (the main user wnat single
> pages), but I cannot figure out how to pass options (say I want to print
> duplex or single, etc.) using lpr or lp to the printer from the command
> line. I tried a few standard things ("-o duplex") but they did not seem to
> work. How can a user figure out what the available options are and the
> syntax to use them?
>
> Sincerely,
>
> - Henrik
>
>
>
>
> _______________________________________________
> Redhat-list mailing list
> [EMAIL PROTECTED]
> https://listman.redhat.com/mailman/listinfo/redhat-list
>
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list
