Try this:
find / -name configure -print
and check the paths of the files listed. Deleting a "configure" is not a usual 
procedure AFAIK, if so, untar again or better preview the file names of the tar or rpm 
file.

Francisco


>>> [EMAIL PROTECTED] 29/01/02 17:02 >>>
Perhaps the configure script has to be generated. I forget the usual 
commands that generate the configure script, though.

On Tue, 29 Jan 2002, [EMAIL PROTECTED] wrote:

> Yes, I was in the directory I was supposed to be in. And I looked for 
> "configure" in that directory but I didn't see it. Is it possible that upon
> expanding the file that it did the "configure" automatically? And once
> "./configure" is run does this then remove "configure" from a directory?
> 
> Mark
> 
> ----------
> >From: "Francisco Neira" <[EMAIL PROTECTED]>
> >To: <[EMAIL PROTECTED]>, <[EMAIL PROTECTED]>
> >Subject: Re: ./configure
> >Date: Tue, Jan 29, 2002, 1:21 PM
> >
> 
> > ./configure means "execute configure that exists in this directory". Make
> > sure you are positioned in the directory that actualy contains "configure".
> >
> > Hope this helps
> >
> >
> > Francisco
> >
> >
> >
> >
> > _______________________________________________
> > Redhat-list mailing list
> > [EMAIL PROTECTED] 
> > https://listman.redhat.com/mailman/listinfo/redhat-list 
> 
> 
> 
> _______________________________________________
> Redhat-list mailing list
> [EMAIL PROTECTED] 
> https://listman.redhat.com/mailman/listinfo/redhat-list 
> 

-- 
-Statux



_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED] 
https://listman.redhat.com/mailman/listinfo/redhat-list



_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list

Reply via email to