Hi,
PROBLEM
I'm unable to
perform a fresh-installation of RH7.1 RH7.2 on Adaptec AIC 7896 SCSI
Adaptor.
RH6.2 installation
was doing fine.
On 7.2, the system
was giving endless check after
(SCSI 0) downloading sequencer code... 393 instruction
downloaded.
From then it will go
on and on to check Lun, ID etc... ... But RH 6.2 went on smoothly after
(SCSI 0) downloading sequencer code... 393 instruction
downloaded.
Upgrading from RH6.2
to 7.2 is working fine. And I found that there are additional entry in the
lilo.conf using two boot image namely
1. vmlinuz-2.4.7-10smp
2. vmlinuz-2.4.7-10
vmlinuz-2.4.7-10smp
will boot fine but vmlinuz-2.4.7-10 will give a endless check on SCSI ID and
LUN.
QUESTION
1. What does
smp in vmlinuz-2.4.7-10smp means???
2. Is there
any additional thing that I must specified during the
installation??
Thanks and
regards.
Moke
Tsing
