I believe only the first NIC is auto configured; the rest you need to do
manually with ifconfig. Someone correct me if I'm wrong.
At 07:43 PM 5/4/01 -0500, you wrote:
>I have RH 6.2 installed with 3 3com 905C cards (Tornado). I have the
>3c90x (tornado) drivers compiled into the kernel. I have the cards setup
>this way:
>
>eth0: irq 12
>eth1: irq 11
>eth2: irq 10
>
>For some reason when I run ifconfig I only see one card and loopback
>interface.
>
>I see eth0 but not the others.
>I do the route card and it shows everything setup.
>I can ping the other cards as well.
>
>Any ideas why the cards don't show up using ifconfig???
>
>When I was using the Vortex drivers they all showed up but did not allow
>any access to the network. (wierd)
>
>Randy
>
>
>
>_______________________________________________
>Redhat-list mailing list
>[EMAIL PROTECTED]
>https://listman.redhat.com/mailman/listinfo/redhat-list
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list
