On Wed, 2 May 2001, Priyan Gunatilake wrote:
> Hi,
>
> I am new to linux and have the following
> problem regarding the module
> ne2k-pci.o. FYI, I am runningRedhat 7.0
>
> I have a realtek 8029 pci NIC. During
> bootup, I see a message that says unresolved
> symbols for ne2k-pci.o. Therefore, eth0 is not
> initialized. After some investigation, I found out
> that ne2k-pci.o depends on 8390.o. I found both
> modules in my /lib/modules/2.2..../net/ directory.
> So, I manually tried to load them by
> insmod 8390.o (fine) and then
> insmod ne2k-pci.o which results in again a list
> of messages that say unresolved symbols.
>
> I also tried :
> depmod -a to build the dependancies. Resulted
> in the same error that says unresolved symbols
> modprobe ne2k-pci didn't work either (no surprise)
>
> I'd appreciate any suggestions on how to overcome
> this situation.
>
> Thanks in advance
> --priyan
>
> PS. I am using the ne2k-pci.o and 8390.o provided
> by the Redhat installation found in /lib/modules/../net
> directory. The etc/modules.conf says
> alias eth0 ne2k-pci
> alias parport_lowlevel parport_pc
>
>
Try "modprobe ne2k-pci" and see if that works without problems.
Mikkel
--
Do not meddle in the affairs of dragons,
for you are crunchy and taste good with ketchup.
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list
