Pretty sure these are ISA NICs. Typically, ISA won't be auto-detected 100%.
You'll need to:
1) Set some jumpers to a specific IRQ/IO
or
2) Get the current config by using a DOS config diskette (or installing
Windows), if jumperless.
Then try to load 'insmod 3c509 irq=X' to see if the module will load.
That's a good start...
Marco
----- Original Message -----
From: "Carson, Chuck" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Tuesday, October 31, 2000 12:18 PM
Subject: RH62 and 3com 3C9X
>
> After tossing RH7 into the trash can after many many glibc woes, I am
going
> to step back to RH62. However, it has a 3Com 3c905 NIC, which it is not
> detecting. (This box was a SuSe box before trying RH7) Do I need to get a
> newer kernel and recompile, or is there something I can do at install time
> to detect this NIC?
>
> Thanks greatly,
> Chuck
>
>
>
> Chuck Carson Sr. Systems Engineer
> 858.909.3505 Office eBuilt.com
> 760.212.5899 Mobile San Diego, CA
>
>
>
>
> _______________________________________________
> Redhat-list mailing list
> [EMAIL PROTECTED]
> https://listman.redhat.com/mailman/listinfo/redhat-list
>
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list
