I have been running RH 6.0 and used the setup scrip provided by Promise
for 6.0. I wanted to upgrade to 6.2 but the same script did not work
with 6.2. After looking for a while I found the method to use in the
mini "How To for Ultra 66" This worked fine. (It involved issuing the
command "Linux ide2=XXXXXXXXXX
ide 3=XXXXXXXXXXXXX before booting Linux). I have successfully put this
command into LILO so I don't have to enter it with each boot,
everything seems to work well except: RH 6.2 runs a LOT SLOWER!!!!
than 6.0 did. Is this the nature of 6.2? Or is something else wrong
which I need to address? Or do I need to patch the 2.2.14 kernel? (if
this is the case then I need some advise, I have found a lot of patches
supplied by /hederick/ but which one? and how to apply it? I can
probably figure out how to apply the patch but I am in the dark as to
which patch to use. So, any advise and direction would be welcome from
You-Who-Know more than I do about Linux (I'm still very much a work in
progress).
Michael
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list
