Greg,
Thanks. 'ifconfig' reports that both NICs {Linksys PCI 10/100
ethernet] have the same IRQ. I will check LinkSys' web site to see if
there is a utility to set the IRQ on one of the boards.
Thanks,
Bob
Greg Wright wrote:
>
> *********** REPLY SEPARATOR ***********
>
> On 5/07/00 at 23:49 Bob Hartung wrote:
>
> >Okay, I had no problems getting ipmasq and ipchains going on RH 6.0 but
> >I am having a devil of a time with 6.2 that is after I got the correct
> >installer disk image. Question now is that I have two NICs in the
> >machine how do I tell which is assigned as eth0 and which eth1?
> >
> >Not a problem before because I had a dial up connection forced up for 12
> >hours a day.
> >
> >Keep the bombs small
> >
>
> You should know the IRQ of each NIC , you will be able to look at the
> networks scripts, or you can use linuxconf etc to see which is which. If
> you are not sure of IRQ's get them by booting with a DOS disk and running
> the cards utility program.
>
> Regards
>
> Greg Wright
> --
>
> IT Consultant Sydney Australia PH 0418 292020
> Available for Global Contracts Int. +61 418 292020
> web http://www.ausit.com e-mail greg AT ausit.com
> Trading As - AAA Computers, ITpro, Ozzie Soft, providers of IT services.
>
> --
> To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
> as the Subject.
--
Bob Hartung
www.radiologygrouppc.com
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
