Hello all,
I recently installed a linux box--Redhat 6.1(Cartman)
by customize install,during which i am not asked to 
config network.so i use ifconfig & route to setup the
networking env. after reboot,but it didn't work.Who can
tell me what's wrong with it?
thanks a lot
Brad

P.S. :
route information:
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
172.16.49.33    *               255.255.255.255 UH    0      0        0 eth0
172.16.49.0     *               255.255.255.128 U     0      0        0 eth0
127.0.0.0       *               255.0.0.0       U     0      0        0 lo
default         172.16.49.1     0.0.0.0         UG    0      0        0 eth0
ifconfig information:
eth0      Link encap:Ethernet  HWaddr 00:20:AF:DA:38:2C  
          inet addr:172.16.49.33  Bcast:172.16.49.127  Mask:255.255.255.128
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100 
          Interrupt:10 Base address:0x300 

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          UP LOOPBACK RUNNING  MTU:3924  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0                                 


-- 
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.

Reply via email to