Hi, John,
John Aldrich wrote:
>
> I've got two SCSI controllers in my system currently, but
> despite the fact that both of them are in conf.modules,
> only one will have the module installed at boot. One is an
So can you do an insmod on the other module and have both working?
> Advansys ABP-940UA, and the other is an on-board Adaptec
> Ultra-Wide (I *think* it uses the AIC-7xxx module.)
I have a motherboard with on-board Adaptec AIC-7890 and a PCI ncr53c810
50-pin narrow scsi controller. Both modules install fine at boot-up.
You might want to check out the Advansys Web site tech page
http://www.advansys.com/support/techspec.htm. There's a note about
motherboard support.
Good luck,
Hidong
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
