So, I have finally connected to AT&T Worldnet...
but now I can't see beyond their nameserver...
here is some info I captured...
#ifconfig ppp0
ppp0 Link encap:Point-to-Point Protocol
inet addr:32.100.59.236 P-t-P:204.146.240.42
Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1
RX packets:10 errors:0 dropped:0 overruns:0 frame:0
TX packets:10 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:10
#route -n (After ppp is connected)
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
199.1.1.1 0.0.0.0 255.255.255.255 UH 0 0 0
eth0
204.146.240.42 0.0.0.0 255.255.255.255 UH 0 0 0
ppp0
199.1.1.0 0.0.0.0 255.255.255.0 U 0 0 0
eth0
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0
lo
#resolv.conf
search ilmtech.com
search worldnet.att.net
nameserver 199.1.1.1
nameserver 204.127.160.2
nameserver 204.127.129.2
#host.conf
order hosts,bind
multi on
#nslookup
*** Can't find server name for address 199.1.1.1: No response from
server
*** Can't find server name for address 204.127.160.2: No response from
server
*** Can't find server name for address 204.127.129.2: No response from
server
*** Default servers are not available
I can ping the nameserver 204.127.160.2 and 204.127.129.2 but I can't do
more than this.. For example I can't ping beyond the nameserver...
Any ideas where I'm going wrong?
thanks,
Ahbaid.
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
