Well, i'm sort of stuck right now. I've been working with LILO for a while
and it's always worked and now i'm running into trouble. Here's the setup:
On the motherboard
Pri IDE Channel
MASTER: Hard Drive 1 (IBM 8GIG) Redhat Linux 6.0
SLAVE: Hard Drive 2 (WDC 2GIG) NT 4.0 Workstation
Sec IDE Channel
MASTER: DVD ROM
SLAVE: 100MB Zip Drive
Promise PCI Ultra ATA 66 Card
Pri IDE Channel
MASTER: Hard Drive 3 (IBM 34GIG) Windows 98
and the rest of the card is empty. Now I had this config working by booting
them using lilo about 2 weeks ago. Then i need to reinstall windows 98
because well, you know how windows is...so afterwards i couldn't boot nt
without getting the bsod. The problem is the drive was not being correctly
mapped. I was wondering if anyone has this config working, or a similar
config working with 3 drives. I tried moving them around but for some
reason linux won't boot if its hdb but nt works fine, meanwhile windows98
won't boot on either config plus it needs to stay on the PCI card because
it's ATA 66. The problem is not with the card by the way, i've already
checked it out and everything works fine (modules are installed for 6.0)
plus i had it working before. At any rate, if anyone could suggest
something to change, or could point to a howto, that would be great.
Thanks.
Jeff
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
