At 12:36 AM 4/25/00 +0430, Maziar Mahzari wrote:
>Mikke;
>I put the modem right in the same port. However, the former one was
>detected on ttys1 (com2) whereas the new modem is detected on ttys3
>(com4). I set the same setting in kppp which has a modem control utility
>too.
>I don't use the link to modem, I set it ttys3 in control panel->modem.
>moreover, it works fine with minicom.
>Thanks very much
>Maziar
>
I am not sure what is going on then - the hardware is working seance it works
in minicom.  About the only thing I can think of is if you are really using
ttys3 in kpp, instead of ttyS3...  If you had the interrupt wrong, or were
trying to share an ISA interrupt, you would notice delays in modem response
when using minicom.  I hope someone else has an idea, because I am fresh out!

Mikkel


--
    Do not meddle in the affairs of dragons,
 for you are crunchy and taste good with ketchup.


-- 
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.

Reply via email to