Hi all,
I just installed 6.2 on a machine and have found a few minor problems to
fix.
1.The first is networking when the machine boots and I log on and run
ifconfig eth0 doesn't showup. However if I just look at the basic host
info in linuxconf and then type ifconfig eth0 shows up and I can telnet
and ftp on my intranet. I checked ntsysv and it shows that network
should start automatically. In my log I found this message which may be
the source of the problem
ismod:Note: /etc/conf.modules is more recent than
/lib/module/2.2.14-5.0/modules.dep
If found the card and setup the addresses with the install but I used
linuxconf to set the machine name so this may have caused the problem.
2. I would like lilo to default to dos as this machine is used mostly for
scanning and printing photos I also use it to practice linux to linux and
linux to windows networking stuff before I do them at work I tried
changeing lilo.conf default=dos but it still booted linux. Smart machine.
(I will be thrilled when corel Draw and my scanner work with linux so I can
scrap windoze but for now...)
3. In xfce I get a huge square for a cursor. I tried to add
Option "sw_cursor"
to the configuration file but I either have the wrong syntax, the wrong
place, or
the wrong file as it doesn't help.
Thanks
Linda
Also Thanks for everyones help with the hard drive so far it is working fine
if it happens again I will try the bad block check.
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
