> The kernel was properly upgraded. However, as with the 6.1 install, I
> was given two kernels, one for an smp configuration, which was made
> the default. Problem is this is a single processor machine. I do
> believe (I'll check to be sure) that there is a slot for a second
> processor (Dell P-III 733 Workstation 220). Most likely, the
> installer detects slots, not processors? Both kernels boot, the
> non-smp being the better one.
I had the opposite problem where I did not get an smp kernel on my dual
p3-650 Netfinity 5000 system. In all fairness to the upgrade, 6.1 didn't
detect it as a smp system either, but I had compiled my own kernel with
smp support.
Regards,
Trevor Astrope
[EMAIL PROTECTED]
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
