I don't think this is true. I have used a stock RH6.1 kernel with two
idnetical cards using a module.
On Tue, 28 Mar 2000, Jason Bradley Nance wrote:
> If the NIC's use the same modules you must compile that module in to the
> kernel (* not M).
>
>
> > -----Original Message-----
> > From: Joe [mailto:[EMAIL PROTECTED]]
> > Sent: Tuesday, March 28, 2000 11:37 AM
> > To: Red Hat Mailing List
> > Subject: Installing a 2nd NIC
> >
> >
> > I want to install a 2nd NIC (eth1) so I can use my cable modem but I can't
> > get my system to recognize it. I know the NIC (3c515) is good since 1)
> > I've been using it in my other system and 2) I do see traffic getting to
> > it. However, I can't get the driver to install:
> >
> > /sbin/insmod 3c515
> > /lib/modules/2.2.12-20/net/3c515.o: init_module: Device or resource busy
> >
> > I did add an entry in my /etc/conf.modules: "alias eth1 3c515".
> >
> > Meanwhile the 3c59x driver for my 3c905B loads up no questions asked.
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
