I have tried searching the redhat site and found nothing specific.  Where can I 
find SPECIFIC instructions to get RH6.0/6/1 installed on an EXISTING 
Windows2000 Pro installation.  I am looking for something which is UPTO DATE 
and not some old howto from 1997 and the first revision of NT4.

A little side info....

I have a 4.2GB IDE drive sitting at the first device (IDE-0). There is a little 
300mb fat32 partition there from an existing Win98 install. The remaining 3.9GB 
is unclaimed and awaiting RH Linux.  Win2K resides on two other scsi devices.  
Win98SE + RH6.0 was an easy dual boot config but I can't afford to screw up the 
existing Win2K install.

Thanks a lot,

jon shoberg
[EMAIL PROTECTED]



1


-- 
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.

Reply via email to