On Tue, Jan 04, 2000 at 12:00:37PM -0500, Erik wrote:
> Hi,
>
> I get sig 11 eroors when I compile things. I know that this is
> suppoosed to be a hardware problem, but I have tested it with other
> memory and it works fine. I have an AMD K6-2 450. My problem is when I
> compile the kernel, it might crash, but i can just run 'make bzImage'
> again and it would eventually finsh and be fine. I am trying to compile
> a rpm from the source and a spec file but i get a sig11 error in the
> midlle of the process. if i run the 'rpm -ba foo.spec' command again it
> starts all over. does anyone know of a solution besides getting a new
> computer? I dont have access to another computer to compile it on.
There are other things that can cause a sig11: overheating, bad
motherboard, bad IDE cables...
http://www.bitwizard.nl/sig11/
--
Steve Borho Voice: 314-615-6349
Network Engineer
Celox Communications Corp
Fortune of the day:
Man is the measure of all things.
-- Protagoras
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
