Are you master/slaving these together? Try putting them on the
different controllers (IDE1 and IDE2 Controller)..
Just a suggestion..
Regards,
Steven Hildreth
Information Technology Manager
Aprotex Corporation, http://www.aprotex.com
"Proven Property Protection Since 1952"
----- Original Message -----
From: "Kerry Blalock" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Thursday, December 30, 1999 6:52 AM
Subject: How small is small?
> Hello,
> I am trying to salvage some old hardware for as much of a system as
> possible as a project for my grandson. I have a 486sx25 with 16 meg
ram,
> and two small harddrives. One, a 245 M ibm, the other a 202
Calvalier.
> When setting up Redhat 6.0, I can not get disk druid to partition
the
> drives to a usable state. Everything works, until I try to go
forward
> from here, but I get a message that I have not set up a swap file. I
> have actually set it up, but when I go back, is has been erased.
> I removed the second drive, and am able to get a bare, bare system
> going. Only editor is vi, and no xwindows, gnome, or any other
modules
> from the popup selector. How can I get the second drive enabled for
use?
> Part of the project was to get my grandson to start playing with C
> programing. Would at least like to get that module operating.
>
> Kerry
> --
>
======================================================================
========
> Powered by Red Hat 6.0
> [EMAIL PROTECTED]
>
>
> --
> To unsubscribe: mail [EMAIL PROTECTED] with
"unsubscribe"
> as the Subject.
>
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
