There is no linuxconf setting for this. This is a quasi-undocumented feature. You need to specify it in /etc/conf.modules,example: options 3c509 irq=9,10 xcvr=0,3 says the first 3c509 NIC uses irq 9, and the 10bt The second 3c905 NIC uses irq 10, and the bnc It may or may not work from the boot command line: linux ether=9,,0,eth0 ether=10,,3,eth1 References: /usr/doc/HOWTO/Ethernet-HOWTO /usr/doc/HOWTO/unmaintained/Module-HOWTO /usr/src/linux/drivers/net/3c509.c /usr/src/linux/Documentation/networking/net-modules.txt, et. al. Good Luck J. On Thu, 4 Nov 1999 [EMAIL PROTECTED] wrote: > On Tue, Nov 02, 1999 at 08:45:33PM -0500, jwalsh wrote: > > use the xcvr parameter with your module. > > A comma delimited list, one for each card of that type. > > 0 = 10bt > > 1= aui > > 2 = unknown > > 3 = bnc > > insmod 3c509.o io=blah,blah irq=blah,blah xcvr=0,3 > > would tell it the first card uses 10bt and the second uses bnc. > > Where do you put these lines? I have a simpler problem: I have a > single 3c509 ISA card, and I'd like to tell the kernel to use the 10bt > port. Best would be if you could tell me how to use linuxconf to do this. > > Thx > > Mate > -- To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe" as the Subject.
