Hi all, I have an old Thinkpad 760EL and a 8139 based d-link 690txd ethernet card which just wont work under RedHat 8.0.
The card gets recognized, however in the process the following is printed out: PCI: No IRQ known for interrupt pin A of device 00:02.0 PCI: No IRQ known for interrupt pin B of device 00:02.1 Yenta IRQ list 06b8, PCI irq0 Socket status: 30000020 Yenta IRQ list 06b8, PCI irq0 Socket status: 30000006 cs: cb_alloc(bus 1): vendor 0x1186, device 0x1340 PCI: Enabling device 01:00.0 (0000 -> 0003) PCI: No IRQ known for interrupt pin A of device 01:00.0 cs: IO port probe 0x0c00-0x0cff: clean cs: IO port probe 0x0100-0x04ff: excluding 0x220-0x22f 0x268-0x26f 0x330-0x337 0x388-0x38f 0x3b8-0x3df 0x4d0-0x4d7 cs: IO port probe 0x0a00-0x0aff: excluding 0xa68-0xa6f 8139too Fast Ethernet driver 0.9.25 PCI: No IRQ known for interrupt pin A device 01:00.0 PCI: Setting latency timer of device 01:00.0 to 64 divert: allocating divert_blk for eth0 eth0: D-Link DFE-690TXD (RealTek RTL8139) at 0xc5073000, 00:40:05:0b:8a:66, IRQ 0 eth0: Identified 8139 chip type 'RTL-8139C' All looks more or less fine and dandy, however there is no network connectivity. If I do ifdown eth0 and then ifup eth0, I get: SIOCSIFFLAGS: Device of resource busy After a slight wait, ifup returns with the message "failed" (I am using dhcp). Any ideas? Thanks, Ognen -- redhat-list mailing list unsubscribe mailto:[EMAIL PROTECTED] https://www.redhat.com/mailman/listinfo/redhat-list
