Hi all,
I'm having trouble getting my ethernet to work after swapping motherboards.
New details are:
- NEXCOM Peak 650 single board computer
- Integrated Intel 82559 ethernet
- RH 6.0
>From what I've found out I should be using the EtherExpressPro/100 (eepro100.o)
driver.
At boot the ethernet initialisation is delayed and ifconfig shows that eth0
does not exist. I tried to modprobe the eepro100.o driver but get a message
something like "module init is busy". Since lsmod shows no eepr100 I figured
this was due to an IRQ or ioport conflict however /proc/pci shows the
ethernet controller (IRQ=11 & IO=0xc000), but /proc/interrupts does not show
any conflicting device on IRQ 11.
I'm a little new to this and am starting to run out of ideas.
Hope someone can help.
Thanks,
Karl Rentsch
PS. Upgrading to a newer version of RH is a last resort due to other setups.
--
redhat-list mailing list
unsubscribe mailto:[EMAIL PROTECTED]?subject=unsubscribe
https://listman.redhat.com/mailman/listinfo/redhat-list
