|
I would guess since you ran up2date, you updated kernel rpm as
well? Maybe to 2.4.18-X?
I saw this same thing, when I installed 8.0 yesterday, except with
hdc (first cdrom) both my hard disks were fine. I hadn't seen this in
6.2 or 7.3 running same hardware, so I suspected some sort of
change on the install.
I upgraded to 2.4.20 (not because of this, because I
wanted to), and using essentially same config; problem immediately
went away, any chance that kernel-2.4.18.X might have
a problem from RH?
-------Original
Message-------
Date: Tuesday,
February 04, 2003 08:06:11
Subject: Hard disk
problems
Managed to install redhat 7.1 and up2date it on two
computers this
weekend after struggling with a few issues and thanks
to the help I
received here finished without problems. The machines
are running great.
I've installed 7.1 on a third machine last
night. However, I'm running
into a problem.
This shows up
after I've logged in.
hda: timeout waiting for
DMA
ide_dmaproc: chipset supported ide_dma_timeout
func only:
14
hda: irq timeout: status=0x58 {Drive Ready SeekComplete
DataRequest}
hda: DMA disabled
hda: Drive not ready for
command.
Does this mean the hard drive is bad? Or is something
else going on? I
can't run fsck because no prompt is available.
I
tried re-installing with a check for bad blocks. It took a
little
longer but the install occurred. I was able to log on again,
but
started receiving this above message again.
Any
advice?
Ernie
--
redhat-list mailing
list
unsubscribe mailto:[EMAIL PROTECTED]?subject=unsubscribe
https://listman.redhat.com/mailman/listinfo/redhat-list
.
| 
