I have a 3Com Etherlink III 3c5905TP which is causing a lot of headaches. I have re-installed RH Linux 7.1 During its original installation this card worked fine.
On the new install, the card isn't recognized by the install program. I booted up in plain DOS and used 3Com's auto configure routine. I tested the card and it passed all the tests. Using the auto config the card was set to IO address 300h The IRQ was set to 10 I ran linuxconf to configure the card. I set it's IP address And set the IO address to 300 and IRQ to 10 I set the kernel module to 3c509 from the drop down box. Saved the configuration and did a /etc/rc3.d/S10network reload The card failed. On boot eth0 fails with an insmod bad parameter. Does anyone have a clue about what is failing? How do I find out what parameter is bad. Ernie -- redhat-list mailing list unsubscribe mailto:[EMAIL PROTECTED]?subject=unsubscribe https://listman.redhat.com/mailman/listinfo/redhat-list
