> On Thu, Jan 09, 2003 at 04:20:49PM -0600, Mike Vanecek wrote: > > Spamassassin 2.43 uses perl-5.6.1 (RH 7.3). RH 7.1 uses perl-5.6.0. > > > Is there a way to just install the two missing .pm's? Would using 5.6.1 pm's > > with 5.6.0 perl cause a problem? If it can be done, where would I get the > > two missing pm's? > > I've installed spamassassin 2.42 on RH 7.3 - I ran into similar > problems, as the spamassasin RPM is based on RH 8.0. I simply went > ahead and installed the SRPM, removed all *explicit* (i.e. given in > the spec file) perl requirements, then did a rebuild. It would then > complain about missing modules, which I then found via rpmfind.net. I > had to --rebuild most of them, but in the end it worked just fine.
I guess maybe I could have found the missing modules on cpan.org. I could not figure out how to use rpmfind.net to get just the missing modules. I upgraded perl to 5.6.1 (required about downloading and installing about 6 or 7 rpms from 7.3). It zapped openwebmail until I got the cgi-perl.rpm too. Hopefully, nothing else will bomb. It was a little scary since the system is a virtual domain server rather than a standalone machine. I was worried I might zap something in the VE engine from the SwSoft vendor. Now I will go see if I can get spamassassin to start and run... -- redhat-list mailing list unsubscribe mailto:[EMAIL PROTECTED]?subject=unsubscribe https://listman.redhat.com/mailman/listinfo/redhat-list
