I have a laptop, a wired network card that takes up both pcmcia slots and a wireless network card. I'm trying to figure out how to set these up as seamlessly as possible. I can't have them both installed at the same time because they won't fit, and when I take one out and put in the other, linux has an idenity crisis.
I'm setting this up using the RH8 network control panel which may be part of my problem. I'm trying to use this because I want to set up different network profiles. The problem is that it always thinks that the card that is installed is supposed to be eth0. but the two cards use different kernel modules and the entry in /etc/modules.conf says that eth0 uses the module for whatever card I have installed last. Can I modify the configuration so it will know to load the proper kernel module and not have one hard coded into modules.conf? Or can I configure pcmcia so that when the wired net card is removed and the wireless card is installed to make it eth1? -- Jeff Bearer, RHCE Webmaster, PittsburghLIVE.com Winner 2002 Eppy Award, Best U.S. Newspaper Website -- redhat-list mailing list unsubscribe mailto:[EMAIL PROTECTED]?subject=unsubscribe https://listman.redhat.com/mailman/listinfo/redhat-list
