Actually if you just installed, it may be simplier to reinstall it.
When it comes to the LAN bit, enter NE2000, then specify options.
io=0x300 irq=11
Should work in a pinch.
Dan
At 02:02 PM 3/28/98 -0800, Dan Cyr wrote:
>
>Add this to your kernel option in /etc/lilo.conf
>
>append="ether=10,0x300,eth0"
>
>10 = Network cards IRQ
>0x300 = Network cards IO Base
>
>eg. Mine is set for 2 network cards.
>image=/boot/vmlinuz
> label=linux
> root=/dev/sda1
> initrd=/boot/initrd
> read-only
> append="ether=10,300,eth0 ether=2,320,eth1"
>
>
>Then run /sbin/lilo.
>
>
>Edit the following scripts to appear somthing as mine.
>
>
>#/etc/sysconfig/network
>NETWORKING=yes
>#FORWARD_IPV4=yes
>HOSTNAME=linux.dan-hender.com
>DOMAINNAME=dan-hender.com
>#GATEWAY=192.168.0.254
>#GATEWAYDEV=eth0
>
>#/etc/sysconfig/network-scripts/ifcfg-eth0
>DEVICE=eth0
>IPADDR=192.168.0.2
>NETMASK=255.255.255.0
>NETWORK=192.168.0.0
>BROADCAST=192.168.0.255
>ONBOOT=yes
>BOOTPROTO=none
>
>
>Good luck.
>
>Dan
>
>
>At 03:43 PM 3/28/98 -0500, Eduardo Egues wrote:
>>
>>I just installed redhat-5.0 and my network card don't work. I tried with
>>Microdyne NE2000 Compatible and with an Accton EN166X MPX (PNP and
>>jumperless options had been tested) following networking installation
>>steps.
>>
>> Where do i can find driver for Accton card?
>> Any other sugestions?
>>
>> TIA
>>
>>
>>____________________________
>>Eduardo Egues
>>[EMAIL PROTECTED]
--
PLEASE read the Red Hat FAQ, Tips, Errata and the MAILING LIST ARCHIVES!
http://www.redhat.com/RedHat-FAQ /RedHat-Errata /RedHat-Tips /mailing-lists
To unsubscribe: mail [EMAIL PROTECTED] with
"unsubscribe" as the Subject.
