On Tue, 2 Jun 1998, Mike A. Lewis, CNE wrote:
> John, your wild guess was a good one, but unfortunately not the right
> one. Since posting this message, I have replaced the IDE drive with a
> SCSI drive. Exactly the same problem exists.
[signal 13 problem, that is].
Whenever I've recieved a signal 13 during an install, it signalled flakey
hardware.
I'd start with the memory. That's the most common cause of a signal 13
problem. If you're running a 66mhz chipset at 75mhz, such as e.g. for a
Cyrix 6x86P200, you may need to ramp down the memory timings. Otherwise,
I'd look for a bad memory chip.
Eric Lee Green [EMAIL PROTECTED] Executive Consultants
Systems Specialist Educational Administration Solutions
See http://members.tripod.com/~e_l_green
--
PLEASE read the Red Hat FAQ, Tips, Errata and the MAILING LIST ARCHIVES!
http://www.redhat.com/RedHat-FAQ /RedHat-Errata /RedHat-Tips /mailing-lists
To unsubscribe: mail [EMAIL PROTECTED] with
"unsubscribe" as the Subject.
